Mtd 3BA Instrukcja Użytkownika

Two-Stage Snow ThrowerModel 3BAPRINTED IN U.S.A.Operator’s ManualFORM NO. 769-00747C.fm(7/29/2004)IMPORTANT: Read safety rules and instructions carefu

10• Allow the auger to remain engaged for approximately ten (10) seconds before releasing the auger control. Repeat this several times. • With the eng

11• Remove the self-tapping screw and press the tabs that secure the belt cover to the snow thrower housing. Pull the belt cover from around the engin

12• With engine on level ground, oil must be to FULL mark on dipstick. See Figure 10.• Stop engine and wait several minutes before checking oil level.

13Replacing BeltsNOTE: There are two belts on this snow thrower: augerbelt and drive belt. It is recommended that both belts bereplaced at the same ti

14Off-Season Storage• If unit is to be stored over 30 days, prepare engine for storage as instructed in the engine manual. • Remove all debris from th

15SECTION 9: PARTS LIST FOR MODEL 3BA1245638910111213141516631819204232425262732830313233343529222117Ref. No. Part No. Description1. 710-0449 Carria

16Model 3BA123456789101112131415161718192021222425262829Shown for reference only16Shown for reference only2723

17Ref. No. Part No. Description1. 710-0654A TT Sems Screw 3/8-16 x 1.0”2. 710-0696 Hex Bolt 3/8-24 x 0.875”3. 710-1245B Lock Bolt 5/16-24 x 0.875”4. —

18Model 3BAShown for reference only1523416789101112131416419491621232425262728293031323335363738404120434746474845443422423917185

19Model 3BARef. No. Part No. Description1. 684-04037 Chute Assembly2. 710-04071 Carriage Bolt 5/16-18 x 1.0”3. 710-0451 Carriage Bolt 5/16-18 x 0.750”

2TABLE OF CONTENTSFINDING MODEL NUMBERThis Operator’s Manual is an important part of your new snow thrower. It will help you assemble, prepare and mai

MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESDANGER: This machine was built to be operated according to the rules for safe operation in this manual.

45. Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. 6. Do not operate

5SECTION 2: ASSEMBLING YOUR SNOW THROWERIMPORTANT: This unit is shipped with the engine full of oil. After assembly, see page 8 for fuel and oil deta

6Final AdjustmentsIMPORTANT: Check the adjustments as instructed and make any final adjustments necessary before operating the unit. Check all nuts an

7SECTION 3: KNOW YOUR SNOW THROWER• Compare Figure 6 with your equipment and follow description of controls, given below, to get familiar with their

8SECTION 4: OPERATING YOUR SNOW THROWERBefore Starting EngineEngine OilThe engine is shipped with oil in it. Check the oil level before first use. Fo

9• If your house wiring system is grounded and a three-hole receptacle is not available at the point the snow thrower starter will normally be used, o