Safety • Assembly • Operation • Tips & Techniques • Maintenance • Troubleshooting • Parts Lists • WarrantyWarning: This unit is equipped with an i
10Gas & Oil Fill-Up Service the engine with gasoline and oil as instructed in the Tecumseh Engines manual packed separately with your snow thrower
11Chute Clean-Out ToolThe chute clean-out tool is conveniently fastened to the rear of the auger housing with a mounting clip. Should snow and ice bec
124Making AdjustmentsAuger ControlRefer to Auger Control Test on Page 11 to adjust the auger control.Shift CableIf the full range of speeds (forward a
134Making AdjustmentsWARNINGLoose gravel can be picked up and thrown by the auger, causing injury to the operator and bystanders and/or damage to the
145Maintaining Your Snow ThrowerWARNINGBefore lubricating, repairing, or inspect-ing, disengage all controls and stop engine. Wait until all moving pa
155Maintaining Your Snow ThrowerAuger Belt ReplacementTo remove and replace your snow thrower’s auger belt, proceed as follows:1. Remove the plastic
16Augers• The augers are secured to the spiral shaft with two shear pins and cotter pins. If the auger should strike a foreign object or ice jam, the
17Friction Wheel RemovalIf the snow thrower fails to drive with the drive control engaged, and performing the drive control cable adjust-ment on page
18Preparing EngineNOTE: Refer to the engine manual for more detailed information on preparing the snow thrower engine for storage.Short-Term StorageIt
19NOTE: This section addresses minor service issues. For further details, contact a MTD authorized service center or call 1 (800) 800-7310 for assista
2Finding and Recording Model NumberPlease do NOT return the unit to the retailer from which it was purchased, without first contacting Customer Suppor
20 Styles E & F
219Illustrated Parts ListTo order replacement parts, call 1-800-800-7310 or visit us on the web at www.mtdproducts.com1. 731-2635 Snow Removal
22Styles E & F
239Illustrated Parts ListTo order replacement parts, call 1-800-800-7310 or visit us on the web at www.mtdproducts.comNOTE: Snow thrower features
2412122535350624239634033302436185253719631730242613234547442328432753424 305158526135277145548467595949412111466ABBA826166472917395460575660201015123
259Illustrated Parts ListTo order replacement parts, call 1-800-800-7310 or visit us on the web at www.mtdproducts.comNOTE: Snow thrower features
NOTES26
NOTES27
The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its possessions and
31Safety LabelsWARNINGThis symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property
42Safe Operation PracticesTraining1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble
5Operation1. Do not put hands or feet near rotating parts, in the auger/impeller housing or chute assembly. Contact with the rotating parts can amput
65Setting Up Your Snow ThrowerNOTE: Reference to right and left side of the machine are observed from the operating position.1. Observe the lower re
75Setting Up Your Snow Thrower5. Remove the flat washer and hairpin clip from the end of the chute directional control. Insert the end of the chute
84Operating Your Snow ThrowerNow that you have set up your snow thrower for operation, get acquainted with its controls and fea-tures. These are descr
94Operating Your Snow ThrowerWARNINGThe operation of any snow thrower can result in foreign objects being thrown into the eyes, which can damage your
Komentarze do niniejszej Instrukcji