MTD 27-Ton Instrukcja Obsługi Pobierz pdf (Strona 60)

2010 Log Splitters

Metal fender

To remove/replace a metal fender:

1. Remove the wheel by following the procedures

described in the wheel assembly section of this

chapter.

2. Remove both of the screws that hold the fender to

the tank using a 1/2” wrench.

See Figure 7.11.

3. Install the fender by following the previous steps in

reverse order.

NOTE: The left and the right fenders have the same

part number.

NOTE: There are a lot of bolt holes in the fender to

accommodate all the different models of log

splitters that MTD makes. To find the right

bolt holes to use:

• Align the center bolt hole with the spindle.

• Slide the fender up and down until two of the bolt holes line up with the two holes in the tank.

Figure 7.11

Screws

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 71 72

Brak uwag

MTD 27-Ton Instrukcja Obsługi Strona 60