MTD 31A-2M1A731 Instrukcja Operatora Pobierz pdf (Strona 11)

Pre-Operation Check

The engine is shipped without gasoline in the

engine. See the Set-Up Section of this manual for instructions on

adding gasoline.

Some engines are shipped with oil already in

the engine, others without oil already in the engine. It is very

important to check the oil before operating the engine and

to add if necessary. See the Set-Up Section of this manual for

instructions on checking and adding oil.

For your safety, and in order to maximize the service life of this

equipment, it is very important to check its condition before you

operate this engine. Make certain to service, correct or fix any

problem that might be identified before attempting to operate

this engine.

Improperly maintaining this engine, or

failure to correct any problem before operation can

cause a malfunction which could result in serious

injury or even death.

Always perform a pre-operation inspection before

each operation, and correct any problem.



Fuel Recommendations 1. (See Set Up Section)

Checking Oil Level 2. (See Set Up Section)

Air filter (if equipped) 3. (See Maintenance Section)

General Overall Inspection. Check for any fluid leaks or 4.

discharges, and loose or damaged parts.

Check the owner’s manual provided with the equipment 5.

that is powered by this engine. Review the owner’s manual

for any precautions and procedures that should be

followed before starting the engine.

Starting the Engine

Always keep hands and feet clear of

moving parts. Do not use a pressurized starting

fluid. Vapors are flammable.

An adult should start the engine. Only

allow children to start the engine if an adult has

determined they are experienced and capable of

such operation.

If you are unable to start this engine

after following instructions in this manual, contact

you authorized MTD Service Dealer. To avoid serious

burn injuries or damage to your engine, DO NOT

attempt to start or troubleshoot this engine in any

other way. for example:

DO NOT use starting fluid.

DO NOT spray flammable vapors into the 

carburetor.

DO NOT put flammable liquids into carburetor. 

DO NOT operate engine or pull on starter rope 

with spark plug removed. Fuel can spray from

spark plug hole and ignite.

NOTE: Allow the engine to warm up for a few minutes after

starting. The engine will not develop full power until it reaches

operating temperatures.

NOTE: Familiarize yourself with the engine symbols shown in

Fig. 5-1 before attempting to start this engine. If this engine is

remotely controlled by the equipment it is powering, be sure to

familiarize yourself with the equipment Operator’s Manual as

well.

NOTE: The following starting instructions are for several different

types of engines. In order to locate the instructions that apply to

your engine, first determine what type of starter you have. If you

have an electric starter, see Engines With Electric Starters. If you

have a manual recoil starter, see Engines with Recoil Starters later

in this section.

Recoil Starter

DO NOT pull starter rope with engine

running. Doing so may VOID YOUR WARRANTY.

To avoid carbon monoxide poisoning, be sure engine is 1.

outdoors in a well-ventilated area.

2.

Manual instructions) is open and all switches are on.

Move the engine speed control, if equipped, to the “FAST” 3.

position.

4.



will be present. Prime engine 5-7 times.

ChokeRun

Fast Slow/Idle Engine Off

Primer



Operation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

MTD 31A-2M1A731 Instrukcja Operatora Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Narzędzia ogrodnicze MTD 31A-2M1A731