MTD RZT Series Instrukcja Operatora Pobierz pdf (Strona 11)

11se c t i O n 4 — cO n t r O l s a n d fe a t u r e s

Figure 4-2

NOTE

: To prevent accidental starting and/or battery

discharge, remove the key from the ignition switch when the

tractor is not in use.

E. Power Take-Off (PTO) Switch



.

Figure 4-3







downward to disengage the clutch.



starting the engine.

F. Transmission Bypass Rods (Not Visible)



transmission) are located beneath the frame platform, just

inside each rear wheel.

When engaged, the two rods open a bypass within the

hydrostatic transmissions, which allows the tractor to be

pushed short distances by hand. Refer to Maintenance &

Adjustments for instructions on using the bypass feature.

CAUTION: Never tow your tractor. Towing

the tractor with the rear wheels on the

ground may cause severe damage to the

transmissions.

G. Cup Holder





H. Storage Tray



J. Seat Adjustment Lever (Not Seen)

The seat adjustment lever is located below the front/left

of the seat. The lever allows for adjustment of the fore to

Maintenance

& Adjustments for instructions on adjusting the seat

position.

K. Fuel Tank Cap



console. Turn the fill cap approximately 1/4 turn and pull

STOP

OFF

START

upward to remove. The fuel cap is tethered to the tractor to

prevent its loss. Do not attempt to remove the cap from the tractor.



turn approximately 1/4 turn clockwise to tighten Always

re-install the fuel cap tightly onto the fuel tank after

removing.

WARNING!: Never fill the fuel tank when the

engine is running. If the engine is hot from

recently running, allow to cool for several



gasoline could splash onto the engine and

cause a fire.

L. Hour Meter / Indicator Panel





Figure 4-4

Hour Meter Features

The hour meter records the hours that the tractor has been

operated in the digital display (tenths of an hour - right

most digit).

NOTE

: The hour meter is activated whenever the ignition

switch is turned to the “ON” position. Keep a record of

the actual hours of operation to assure all maintenance

procedures are completed according to the instructions in this

manual and the engine manual.



indicator light briefly illuminates and the battery voltage

is briefly displayed. The display then changes to the

accumulated hours.

The Indicator Monitor will also remind the operator of

maintenance intervals for changing the engine oil. The LCD



for five minutes after every 50 hours of recorded operation.

The maintenance interval lasts for two hours (from 50-52,

100-102, 150-152, etc.). The LCD will flash as described



during this maintenance interval. Follow the oil change

intervals provided in the engine manual.

y

Indicator





Indicator

rk



Indicator

essure

Indicator



1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag

MTD RZT Series Instrukcja Operatora Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ciągnik MTD RZT Series