Mtd 24638L Instrukcja Użytkownika Pobierz pdf (Strona 6)

— ENGAGEMENT HANDLE IM)

SHOULDER BOLT (A)

Place the flattened end of the engagement handle

(M) down through the slotted bracket beside the

beam. Secure the bottom hole in the handle to

the beam with shoulder bolt (A) and wave washer

(B) as shown in figure 4.

WAVE WASHER (B)

FIGURE 4.

HAIR PIN COTTER (D)

Place the engagement handle in the notch in the

slotted bracket. See figure 5. Thread the ferrule

(C) onto the engagement rod until the ferrule

lines up with the hole on engagement handle.

Secure the ferrule (C) to engagement handle

with flat washer (E) and hairpin cotter (D).

See figure 5.

FIGURE 5.

HAMMER

AXLE PUSH CAP (G)

AXLE

SHAFT (K)

Using a raw hide or plastic hammer, tap one axle

push cap (G) on one end of axle shaft (K). See

figure 6.

FIGURE 6.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Komentarze do niniejszej Instrukcji

Brak uwag