Mtd 242-650A Instrukcja Użytkownika Pobierz pdf (Strona 6)

DRAWSTRING

AND LOCK

CHUTE

DEFLECTOR

7. Place the bag over the chute deflector. Pull on the

drawstring and lock. See figure 6.

FIGURE 6

OPERATION

BEFORE STARTING ENGINE

1. Fill fuel tank with fresh regular gasoline. Do not

mix oil with gasoline.

NOTE

A warm engine may not require

choking.

Fill crankcase with oil. Use MS classification oil.

Do not use oils marked only MM or ML or

unmarked.

Above 32° use SAE 30; below 32° use SAE 10W.

These recommendations must be followed for

best performance and long life.

Position equipment so that engine is level. Re

move oil fill plug. Pour oil into oil fill opening.

Fill to point of overflowing. Pour slowly.

During initial break-in period, oil level should be

watched closely. See maintenance section.

TO START ENGIIME

1. Place control lever (on engine) in "RUN" posi

tion. See figure 7.

2. For cold engine start, move carburetor control

to "CHOKE" position. See figure 7.

FIGURE 7

3. Pull rewind starter using a quick full arm stroke-

Keep a firm grip on the handle and return rop

slowly.

4. After engine starts, move choke lever on carbure

tor gradually to "OFF" position.

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Mtd 242-650A Instrukcja Użytkownika Strona 6