MTD E600E Instrukcja Operatora Pobierz pdf (Strona 11)

Crankclockwisetodischargetotheleft.

Crankcounterclockwisetodischargetotheright.

ThrottleControl

The throttle control is located on the engine. It

regulates the speed of the engine. See Figure 14.

SafetyIgnitionSwitch

The ignitionkey must be inserted in the switch before

the unit wiltstart. Remove the ignition key when snow

thrower is not in use.

Fuel Shut-off Valve

(If Equipped)

The fuel shut-off valve,

located under fuel tank,

controls fuel flow from

tank. See Figure 13.

C,o,ed

Open _ L_J I

Figure 13

Choke

Key

Throttle

Control

Figure 14

Primer

Handle

SECTION5: OPERATINGYOURSNOWTHROWER

BeforeStarting

,_ WARNING: Read, understand, and follow

all instructionsand warnings on the machine

and in this manual before operating.

The spark plug wire was disconnected for safety.

Attach spark plug wire to spark plug before

starting.

GasAndOilFill-up

WARNING: Use extreme care when

handling gasoline. Gasoline is extremely

flammable and the vapors are explosive.

Never fuel machine indoor or while the

engine is hot or running. Extinguish

cigarettes, cigars, pipes and other sources

of ignition.

A plastic cup was provided inside the fuel fill

opening on the fuel tank. Remove and discard this

cup before filling up the tank. Use the separate

fuel tank cap to close after fill-up.

StartingEngine

Attach spark plug wire to spark plug. Make certain

the metal loop on end of the spark plug wire

(inside the boot) is fastened securely over the

metal tip on the spark plug. See Figure 15.

Metal

Plug Wire

.,_Rubber Boot

Figure 15

Make certain the fuel shut-off valve is inthe OPEN

(vertical) position.

Make certain the auger and traction controls are in

the disengaged (released) position.

Move throttle control up to FAST position. Insert

ignition key into slot. Be certain it snaps into place.

Do not turn key. See Figure 16.

NOTE: Engine will not start unless ignition key is

inserted into ignition slot in carburetor cover. Do not

turn ignition key.

RecoilStarter:

Rotate choke knob to FULL choke position (cold

engine start).

If engine is warm, place choke in OFF position

instead of FULL.

Push primer button three or four times for cold

engine start.

If engine is warm, push primer button once only.

NOTE: Always cover vent hole in primer button when

pushing. Additional priming may be necessary for first

start if temperature is below 15 degrees Fahrenheit.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

MTD E600E Instrukcja Operatora Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pługi wirnikowe MTD E600E