MTD 769-01275C Instrukcja Operatora Pobierz pdf (Strona 12)

Mak=ng

Adjustments

WARNING

Read, understand,

and follow all instruc-

tions and warnings

on the machine and

in this manual before

operating.

Never attempt to

make any adjust-

ments while the

engine is running,

exceptwhere speci-

fied in operator's

manual.

Auger Control

Referto AugerControlTeston Page11to adjustthe

augercontrol.

Shift Cable

If thefull rangeof speeds(forwardandreverse)cannot

beachieved,referto the figuresto the rightandadjust

the shiftcableas follows:

1. Placethe shiftleverinthe fastest forwardspeed

position.

2. Loosenthe hex nuton the shiftcable indexbracket.

SeeFigure3.

3. Pivotthe bracketdownwardto takeupslack inthe

cable.

4. Retightenthe hex nut.

Drive Control

Whenthe drivecontrolisreleasedandinthe disen-

gaged"up" position,the cable shouldhaveverylittle

slack.It shouldNOTbetight.

Checkthe adjustmentof the drivecontrolas follows:

1. Withthe drive controlreleased,pushthe snow

throwergentlyforward.The unitshouldrollfreely.

2. Engagethe drivecontroland gentlyattemptto push

the snowthrowerforward.Thewheelsshouldnot

turn.The unit shouldnotrollfreely.

3. Withthe drive controlreleased,movethe shift lever

backandforth betweenthe R2positionandthe F6

positionseveraltimes.There shouldbe noresistance

inthe shiftlever.

4. If anyof the abovetestsfailed,the drive cableis in

needof adjustment.Proceedasfollows:

5. Loosenthe lowerhexnut onthe drivecable bracket.

SeeFigure4.

6. Positionthe bracketupwardto providemoreslack (or

downwardto increasecabletension).

7. Retightenthe upperhexnut.

Chute Assembly

Thedistancesnowisthrowncan beadjustedby chang-

ingthe angleof the chuteassembly.Todo so:

1. Stopthe engineby removingthe ignitionkeyand

loosenthe plasticwing knobfound onthe left sideof

thechuteassembly.

2. Pivotthe chuteupwardordownwardbeforeretight-

eningthe wingknob.SeeFigure5.

Figure 3

Figure 4

Figure 5

)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

MTD 769-01275C Instrukcja Operatora Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pługi wirnikowe MTD 769-01275C