MTD 31AE5MLG729 Instrukcja Operatora Pobierz pdf (Strona 12)

Auger Control

To adjust the auger control, refer to page 10.

Shift Cable

If the full range of speeds (forward and reverse) cannot

be achieved, refer to the figure to the left and adjust the

shift cable as follows:

1. Place the shift lever in the fastest forward speed

position.

2. Loosen the hex nut on the shift cable index bracket.

See Figure 10.

3. Pivot the bracket downward to take up slack in the

cable.

4. Retighten the hex nut.

5. Check for correct adjustment before operating the

snow thrower.

Chute Directional Control

If the chute assembly does not have full range from

left-to-right, the chute control cables can be adjusted to

take up slack:

1. Using a ½” wrench, loosen the upper and lower hex

nuts found on one cable adjuster.

2. Grasp the metal cable housing and gently push

upward to take up slack (usually no more than 1/4-

inch) in the cable before retightening both hex nuts.

3. Repeat on the other cable adjuster until the chute

assembly has full range from left-to-right.

See Figure 11.

Skid Shoes

The space between this shave plate and the ground can

be adjusted. For close snow removal, move the skid

shoes upward on the auger housing. Move the skid shoes

downward on the auger housing when area to be cleared

is uneven.

1. Adjust skid shoes by loosening the four lock nuts

and carriage bolts and moving skid shoes to desired

position. See Figure 12.

2. Make certain the entire bottom surface of skid shoes

are against the ground to avoid uneven wear on the

skid shoes.

3. Tighten nuts and bolts securely.

IMPORTANT: It is not recommended that you operate

this snow thrower on gravel, as loose stones can be

easily picked up and thrown, resulting in personal injury

or damage to the snow thrower. If for some reason, you

must operate the snow thrower on gravel, adjust the skid

shoes for maximum clearance between the ground and

the shave plate.

Making

Adjustments

Figure 10

Figure 11

Figure 12

WARNING

Read, understand,

and follow all instruc-

tions and warnings

on the machine and

in this manual before

operating.

Never attempt to

make any adjust-

ments while the

engine is running,

except where speci-

fied in operator’s

manual.

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

MTD 31AE5MLG729 Instrukcja Operatora Strona 12

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pługi wirnikowe MTD 31AE5MLG729