MTD TBBC Instrukcja Operatora Pobierz pdf (Strona 7)

INSTALL AND ADJUST THE D-HANDLE

1. Push the D-handle down onto the shaft housing so

that the handle slants towards the shaft grip (Fig. 1).

The squared bolt hole in the handle is to the right.

2. Insert the shoulder bolt into the squared hole in the

handle and push through. On the left side of the

handle, place the washer on the bolt, then screw the

wing nut onto the bolt. Do not tighten until you make

the handle adjustment.

3. Rotate the D-handle to place the grip above the top

of the shaft housing. Place it a minimum of 6 inches

(15.24 cm) from the end of the shaft grip.

D-Handle

Tighten

Minimum

(15.24 cm) Wing Nut

Bolt _ Washer

Fig. 1

4. While holding the unit in the operating position

(Fig. 2), position the D-handle to the location that

provides you the best grip.

5. Tighten the wing nut until the D-handle is secure.

INSTALL THE CUI-I'ING ATI'ACHMENT SHIELD

Use the following instructions if the cutting attachment

shield on your unit is not installed.

IAIAD I 11 • Never operate the

I • • rim • n• mn• _ • trimmer without the

cutting attachment shield in place to

prevent serous persona njury.

Place the cutting attachment shield onto the shaft

housing. Be sure the guard mounting bracket slides

into the slot on the edge of the cutting shield. Rotate

the shield into place, counterclockwise. The holes in

the guard mounting bracket and cutting attachment

shield will line up (Fig. 3).

Shaft Housing

Guard

Mounting

Bracket

Cutting Attachment

Shield

Fig. 3

From inside the cutting attachment shield, push the square

bolt through the hole until the threaded end protrudes

through the guard mounting bracket (Fig. 4).

Guard

Mounting

Bracket

isher

Fig. 2

Square Bolt

Fig. 4

Wing Nut

3. Put the washer on the bolt, then screw the wing nut

onto the bolt and tighten. Figure 5 shows the

installation process from underneath the unit.

Square Bo_

Cutting //\ II r , .

Attachment //_ _ L,_ wasner

Shield _- It =

-/ _J _-_Win- Nut

Cutting Attachment and Shield: Underside View

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Komentarze do niniejszej Instrukcji

Brak uwag

MTD TBBC Instrukcja Operatora Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Podkaszarki do trawy MTD TBBC