Mtd 110A508R000 Instrukcja Użytkownika

$1.00OWNER'S GUIDEASSEMBLY • OPERATION • MAINTENANCE • PARTS22"ROTARYMOWERModel Number 110A508R000Important: Read Safety Rules and Instructi

2. Open fuel shut-off valve. See figure 13.FIGURE 13.3. Move throttle control lever all the way forward.4. Standing behind the unit, depress the bl

THROTTLE CONTROL ADJUSTMENTIf the throttle control needs adjustment or if it has been replaced, adjust as follows.1. Remove the screw shown in figure

MAINTENANCEAWARNING: Be sure to disconnect and ground the spark plug wire before perf arming any repairs or maintenance.NOTE: When tipping the u

TROUBLE SHOOTING GUIDETroublePossible Cause(s)Corrective ActionEngine fails to start1. Blade control handle disengaged.2. Spark plug wire disconnect

Model A508RPARTS LIST FOR MODEL A508R ROTARY MOWERREFNO. PART NO.DESCRIPTIONREF.NO.PART NO.DESCRIPTION1749-980e*Lower Handle27706-10002FI-Wash. 1/2&qu

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICE BRIGGS AND STRATTON, TECUMSEH AND PEERLESS PARTS ANDParts and service are available through the au

INDEXfelbpe Gauge...3Contents of Hardware Pack...4Rules

iUSE THIS SHEET AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELYkfSIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE----------------A POWER

CONTENTS OF HARDWARE PACKRemove this sheet from your owner’s manual and lay the hardware on the illustration for identification purposes. After assemb

IMPORTANTRULES FOR SAFE OPERATIONTHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/O

IMPORTANT: This unit is Shipped M^ITHOUT GASOLINE or OIL. After assembly, service engine with gasoline and oil as im^ructed in the separate engine man

THBOTTUE=IGURE 4.AHACHING THE THROTTLE CONTROLThe throttle control cable is attached to the engine. Attachthe throttle control to the left side of upp

1/4-20 Hex HutAHACHING THE STABILIZER1. Attach stabilizer to rear brackets with 1/4-20 x 5,, hex bolts, 1/4" split washers and 1/4-20 hex nuts.

CONTROLSThe blade control handle is located on the upper handle of the mower. See figure 10. The blade control handle must be depressed in order to